RANS S-6S
This is the construction log (page 4) for my RANS
S-6S Taildragger.
|
Still taping right side and bottom! |
28
Nov 08Elev trim cable. Finished taping right side. |
Covered left side. Secured antenna with JB Weld. |
Shrunk left side of fuselage and started taping. |
|
More fuselage taping. (just about done) |
Just added one patch today. |
Moved the project indoors for some heat!! |
Working on riveting the ribs in place. |
|
Angle supports under top wrap |
Close out rib, fuel line, leading edge wrap... |
Pitot/static lines installed. Top wrap riveted. |
Bonded the top wrap. |
|
Riveted bottom alum. |
Panel work. |
Bonded the bottom aluminum...again! |
Started covering the left wing!! |
|
Two coats of thinned U-500 |
Gluing the fabric! |
Ironed the top fabric. |
Gluing the bottom fabric. |
|
Glued on all the inspection rings and patches to bottom of L wing. |
Top of wing ready for rib rivets. |
Riveted the top of the ribs. |
Glued the 2" tape over the top of the ribs. |
|
Completed the leading and trailing edge tape. The left wing is done! |
Riveted the top of the right wing. |
General update. Wheel pant alum. mount to axle. Covered R aileron. |
Building a paint booth in my garage. |