I have three things left to do as far as wiring goes:
1. Wire the
transponder
2. Wire the Hobbs
3. Install a 12v receptacle for the GPS
|
|
This part of the wiring is complete. Shown is the wiring for the switch, ignition switches, nav, strobe, radio, and EFIS. |
|
|
I tried to get the wires in nice bundles the best I could. |
|
|
Here are the EFIS and radio wires going down the center. The transponder and radio antenna cables are also routed here. |
|
|
The fuel flow and the E.I.S.
are now complete. If you are super observant, you will notice the light
for the E.I.S. is not connected. The purple wire hanging down goes to
that light but I need to buy the right sized terminals. I have three things left to do as far as wiring goes: 1. Wire the
transponder |
|
|
This is the left side EGT probe. |
|
|
This side works but just looks stupid. It would have been so much neater if I mounted the probe 180 degrees on the exact opposite side of this exhaust pipe. If I had done this, I could have routed the probe wire up the middle with the grey and yellow wire. Oh well. |