 |
Both the wheel pants and
the gear leg fairings are fit. |
 |
Now the tough part-filling
the fiberglass and making the fairings from the wheel pants to the gear
leg. You RV guys should know all about this! |
 |
This is the top of the
glareshield where the frame goes through it. You can see how nice this
side looks... |
 |
This area looks good as is.
The left side is a different story. I basically hacked out the fabric
because there is a black ring that goes around the tube. The ring looks
like crap and I'm not going to use it. So...I ripped the fabric off of
the left side and will put new fabric on this side of the glareshield
and then cut a nice hole like I did on the right side. |
 |
The bolts aren't tight yet
because I need to buy a torque wrench but I installed the prop and added
the coolant. Once I get a new bottom oil hose installed, I can fill it
with oil and run the engine! |