| Another day of various things... | |
 |
I actually built this a few days ago, but this is the flap lever. |
 |
You can see here the flap cable snake its way around to the fitting in the next pic below. I'm not sure if this is the best way to route the cable-I plan on asking Rans... |
 |
Here is the end of the cable with safety wire holding it in the slot. |
 |
This is the lower panel
on the right side of the plane. This panel comes from Rans flat and the
builder has to bend it to fit. I did the left side a while ago and
wasn't happy with the way it fit so I kept putting off doing the right
side. I was just dreading doing this but I completed the right side today and it actually went much faster and MUCH better than the left! In fact, I am going to order a new panel for the left side and redo it. The trick is in WHERE you bend it. Only bend the lower part and not the whole thing. This side looks great! |
 |
Only took about an hour to complete. |