| Sanded off the second coat of Super-Fil on the leading
edge. I also filled in the aluminum skin on the wingtip box. I'll sand
that tomorrow. |
 |
I moved the wing outside to sand off
the Super-Fil. The process makes a lot of blue dust. |
 |
It sure looks like crap but it is
smoooooooth! |
 |
Here's the trailing edge of the top
root skin all finished. |
 |
I started to fit the fiberglass today
but I am not sure exactly where on the top to trim it. I'll wait until
my factory visit on October 1st to see where it gets trimmed at. |
 |
After sanding the leading edge of the
wing for hours and hours, I got bored and wanted to do seomthing else.
So...I used Superflite Reinforcement tape (Item
#: SF-REINFTAPE-1) to tape over all the rivets and sharp edges of the
tail pieces. All my tail pieces are ready to cover. I think once the
sanding is done on the wing I will start covering. |
 |
I used the reinforcement tape (and
don't use masking tape!) to tape over the ribs too since they have a
sharp edge. I cut out the holes where the rivets will go but it may be a
waste of time to do this because there's no way I'm going to cut out
thousands of holes on the wing ribs! |