| Covered the right side of the fuselage. |
 |
First thing I did after laying the
fabric over the side, was cut out the area around the strut attach
fitting. |
 |
Once this is cut out, I could mark a
line on the bottom where I needed to trim the fabric to fit. |
 |
This is after I cut the bottom edge of
the side piece. |
 |
I started at the strut attach fitting
and worked my way towards the back. |
 |
It's a tricky job getting the fabric
around all the curves! |
 |
Here it is all glued...just needs an
ironing job! |
 |
Looks nice once it's smoothed out. |
 |
Done! |
 |
Rivets installed in the tail. |
| |
|