Once again I'm left spending more time scratching my head than building! Here's what I'm doing today...
This is the aft baggage compartment door frame. It looks good in the pic but the bottom forward corner gets confusing. There is note in the manual that says to cut it just aft of the welded tab on the steel cage.
You will need to trim the forward part of the baggage frame. This is what mine looked like after I trimmed it. Notice the notch on the very bottom? This notch is cut out around the weld so that it lays flat. Lots of work you're looking at in this pic!
This is the right side stringer installed. I took a break from the baggage compartment and installed the stringer.
Here's what the rear looks like. Notice the notches I had to cut in the bulkhead to fit the side stringers? Drill a big hole with a drill and then cut the side part off. Not too difficult to do.